ESP-M2 ESP8285 Serial Wireless ,WiFi Transmission Module /มีหน่วยความจำ Flash 1M

ESP-M2 ESP8285 Serial Wireless ,WiFi Transmission Module /มีหน่วยความจำ Flash 1M

ESP-M2 ESP8285 Serial Wireless ,WiFi Transmission Module /มีหน่วยความจำ Flash 1M
– โมดูล Wifi ESP8285 เป็นรุ่นที่พัฒนาต่อจาก ESP8266 ภายในโมดูล ESP8285 = ESP8266 + 1M Flash

Introduction:

What is ESP8285?
ESP8285=ESP8266+1M Flash application temperature up to 125℃! First and foremost the code programmed in ESP8266 could be used for ESP8295 intact.

– ESP-M2 module core processor is the high-performance chip ESP8285, which is equal to ESP8266 chip plus 1M Flash.
– The chip ESP825 is encapsulated an advanced Tensilicas L106 32-bit CPU, together with SRAM. ESP825 has the full and complete WiFi function, which can be used independently and also used as a slave with other Hoster MCU, which can start directly from the out-built Flash. In addition, the built-in high-speed buffer is a benefit for the system performance. Especially, ESP8285 can be used as a WiFi adapter by SPI/SDIO and/or I2C/UART interface, when it is applied to the other MCU design.

Features:
– Ultra-small size;
– Support serial to WiFi;
– Wireless transparent transmission;
– Long distance transmission with ultra-low power;
– Support outboard antenna;
– Bearing high temperature to 125 ℃, compared to the 85℃ for ESP8266.

Specifications:
– SOC characteristics
– Built-in Tensilica L106 ultra-low power 32-bit CPU, main frequency supports 80MHz and160MHz and RTOS;
– Built-in TCP/IP protocol;
– Built-in one-channel 10-bit high precision ADC;
– Outboard interface: HSPI, UART, I2C, I2S, IR Remote Control, PWM, GPIO;
– Deep sleep current is 10uA, the cut-off current is smaller than 5uA;
– Wake, connect and transmission data package within 2ms;
– The consumer power is smaller 1.0Mw (DTIM3) when at standby status;
– Built-in 1M byte for SPI Flash.

WiFi characteristics
– Support 802.11 b/g/n/e/I;
– Support Station, Soft AP, Soft AP+STA mode;
– Support WiFi Direct (P2P);
– Support CCMP (CBC-MAC, computation mode), TKIP (MIC, RC4), WAPI (SMS4), WEP (RC4), CRC etc., for hardware acceleration.
– P2P finding, P2P GO mode/ GC mode and P2P power manage
– WPA/PA2PSK and WPS;
– 802.11securitycertification: pre-certification and TSN
– Support 802.11n (2.4GHz);
– 802.1h/RFC1042 frame encapsulation;
– Support seamless roaming;
– Support AT remote update and cloud update (OTA);
– Support Smart Config function (including Android and Ios device).